Modify igmp snooping settings for a vlan – NETGEAR MS510TXPP 8 Port Gigabit PoE Managed Switch User Manual
Page 139
Smart Managed Pro Switches MS510TX and MS510TXPP
Configure Switching
User Manual
139
The following table displays nonconfigurable information about IGMP snooping for VLANs.
Modify IGMP Snooping Settings for a VLAN
To modify IGMP snooping settings for a VLAN:
1.
Connect your computer to the same network as the switch.
You can use a WiFi or wired connection to connect your computer to the network, or
connect directly to a switch that is off-network using an Ethernet cable.
2.
Launch a web browser.
3.
In the address field of your web browser, enter the IP address of the switch.
If you do not know the IP address of the switch, see
The login window opens.
4.
Enter the switch’s password in the
Password
field.
The default password is
password
.
The System Information page displays.
5.
Select
Switching
> Multicast > IGMP Snooping > IGMP Snooping VLAN Configuration
.
The IGMP Snooping VLAN Configuration page displays.
6.
Select the check box for the VLAN ID.
7.
Update the values.
8.
Click the
Apply
button.
Your settings are saved.
Disable IGMP Snooping on a VLAN and Remove It From
the Table
To disable IGMP snooping on a VLAN and remove it from the table:
1.
Connect your computer to the same network as the switch.
Table 38. IGMP VLAN snooping information
Field
Description
Host Timeout
The period that the switch must wait for a report for a particular group on a
particular interface before it deletes that interface from the group.
This value is calculated as follows: (Query Interval * 2) + Maximum Response
Time.
MRouter Timeout
The period that the switch must wait after sending a query on an interface
because it did not receive a report for a particular group on that interface.
This value is calculated as follows: Query Interval * 2.