beautypg.com

NETGEAR MS510TXPP 8 Port Gigabit PoE Managed Switch User Manual

Page 193

background image

Smart Managed Pro Switches MS510TX and MS510TXPP

Configure Quality of Service

User Manual

193

3.

In the address field of your web browser, enter the IP address of the switch.

If you do not know the IP address of the switch, see

Access the Switch on page

14

.

The login window opens.

4.

Enter the switch’s password in the

Password

field.

The default password is

password

.

The System Information page displays.

5.

Select

QoS > CoS > Advanced > CoS Interface Configuration

.

The CoS Interface Configuration page displays.

6.

Select which type of interfaces display onscreen:

To display physical ports only, click the

PORTS

link.

To display LAGs only, click the

LAGS

link.

To display both physical ports and LAGs, click the

All

link.

7.

Select one or more interfaces by taking one of the following actions:

To configure a single interface, select the check box associated with the interface, or
type the interface number in the

Go To Interface

field and click the

Go

button.

To configure multiple interfaces with the same settings, select the check box
associated with each interface.

To configure all interfaces with the same settings, select the check box in the heading
row.

The Interface Trust Mode column display the globally configured trust mode (see

Configure Global CoS Settings on page

192

). This mode is the same for all interfaces.

8.

The

Interface Trust Mode

field displays whether the selected interfaces trust a particular

packet marking when the packet enters the port. The data for all the ports is taken from the

Global Trust Mode. To set this for a specific port, select one of the following values:

Untrusted

. Do not trust any CoS packet marking at ingress.

802.1p

. The eight priority tags that are specified in IEEE 802.1p are p0 to p7. The

QoS setting lets you map each of the eight priority levels to one of four internal
hardware priority queues.This is the default setting.

DSCP.

The six most significant bits of the DiffServ field are called the Differentiated

Services Code Point (DSCP) bits.

9.

In the

Interface Shaping Rate

field, specify the maximum bandwidth allowed.

This specification is typically used to shape the outbound transmission rate in this range
of 64–10000000 Kbps. The shaping rate (Kb) value is the value of the interface shaping
rate configured. The default value is 0. The value 0 means that the maximum is unlimited.

10.

In the

Interface Ingress Rate Limit

field, specify the ingress rate allowed.

The range is 100 to 10000000 Kbps. The default value is 0. The value 0 means that the
maximum is unlimited.

11.

Click the

Apply

button.