Configure the time settings, Configure the time setting manually – NETGEAR MS510TXPP 8 Port Gigabit PoE Managed Switch User Manual
Page 34
Smart Managed Pro Switches MS510TX and MS510TXPP
Configure System Information
User Manual
34
The following table describes the information that the IPv6 Network Interface Neighbor Table
displays about each IPv6 neighbor that the switch discovered.
Table 6. IPv6 network interface neighbor table information
Field
Description
IPv6 Address
The IPv6 address of a neighbor switch visible to the network interface.
MAC Address
The MAC address of a neighbor switch.
isRtr
• True
. The neighbor machine is a router.
• False
. The neighbor machine is not a router.
Neighbor State
The state of the neighboring switch:
• Reach
. No more than ReachableTime milliseconds elapsed since the switch received
confirmation that the forward path to the neighbor was functioning properly. In the
Reach state, the device takes no special action when packets are sent.
• Stale
. More than ReachableTime milliseconds elapsed since the switch received
confirmation that the forward path was functioning properly. In the Stale state, the
device takes no action until a packet is sent.
• Delay
. More than ReachableTime milliseconds elapsed since the switch received
confirmation that the forward path was functioning properly. A packet was sent within
the last DELAY_FIRST_PROBE_TIME seconds. If no confirmation is received within
DELAY_FIRST_PROBE_TIME seconds of entering the Delay state, the device sends
a neighbor solicitation message and changes the state to Probe.
• Probe
. The switch actively seeks confirmation by repeatedly sending neighbor
solicitation messages each RetransTimer milliseconds until a confirmation is
received.
Last Updated
The last time that the neighbor was updated.
Configure the Time Settings
The switch supports the Simple Network Time Protocol (SNTP). As its name suggests, it is a
less complicated version of Network Time Protocol, which is a system for synchronizing the
clocks of networked computer systems, primarily when data transfer is handled through the
Internet. You can also set the system time manually.
Configure the Time Setting Manually
Use the Time Configuration page
to view and adjust date and time settings.
To manually configure the time setting:
1.
Connect your computer to the same network as the switch.
You can use a WiFi or wired connection to connect your computer to the network, or
connect directly to a switch that is off-network using an Ethernet cable.
2.
Launch a web browser.
3.
In the address field of your web browser, enter the IP address of the switch.