NETGEAR MS510TXPP 8 Port Gigabit PoE Managed Switch - Manual (Page 101)

Smart Managed Pro Switches MS510TX and MS510TXPP
Configure Switching User Manual 101
• T (Tagged) . Select the LAGs on which all frames transmitted for this VLAN are
tagged. The LAGs that are selected are included in the VLAN.
• U (Untagged) . Select the LAGs on which all frames transmitted for this VLAN are
untagged. The LAGs that are selected are included in the VLAN.
By default, the selection is blank, which means that the LAG is excluded from the VLAN
but can be dynamically registered (autodetected) in the VLAN through GVRP.
10. Click the Apply button.
Your settings are saved.
The following table describes the nonconfigurable information displayed on the page.
Table 22. Advanced VLAN membership
Field Definition
VLAN Name The name for the VLAN that you selected. It can be up to 32 alphanumeric
characters long, including blanks. VLAN ID 1 always uses the name
Default.
VLAN Type The type of the VLAN you selected:
• Default . The management VLAN is created automatically. By default,
this is VLAN 1.
• Static . A VLAN that you configured.
• Dynamic . A VLAN created by GVRP registration that you did not
convert to static, and that GVRP can therefore remove.
View VLAN Status
You can view the status of all currently configured VLANs.
To view the VLAN status:
1. Connect your computer to the same network as the switch.
You can use a WiFi or wired connection to connect your computer to the network, or
connect directly to a switch that is off-network using an Ethernet cable.
2. Launch a web browser.
3. In the address field of your web browser, enter the IP address of the switch.
If you do not know the IP address of the switch, see Access the Switch on page 14 .
The login window opens.
4. Enter the switch’s password in the Password field.
The default password is password .
The System Information page displays.
5. Select Switching > VLAN > Advanced > VLAN Status .
The VLAN Status page displays.