beautypg.com

NETGEAR MS510TXPP 8 Port Gigabit PoE Managed Switch User Manual

Page 31

background image

Smart Managed Pro Switches MS510TX and MS510TXPP

Configure System Information

User Manual

31

6.

Select a radio button to determine how to configure the network information for the switch

management interface:

Static IP Address

. Specifies that the IP address, subnet mask, and default gateway

must be manually configured. Enter this information in the fields below this radio
button.

Dynamic IP Address (DHCP)

. Specifies that the switch must obtain the IP address

through a DHCP server.

7.

If you select the

Static IP Address

radio button, configure the following network information:

IP Address

. The IP address of the network interface. Each part of the IP address

must start with a number other than zero. For example, IP addresses 001.100.192.6
and 192.001.10.3 are not valid. The factory default IP address is 192.168.0.239.

Subnet Mask

. The IP subnet mask for the interface. The factory default subnet mask

is 255.255.255.0.

Default Gateway

. The default gateway for the IP interface. The factory default

gateway address is 192.168.0.254.

8.

From the

Management VLAN ID

menu, select the VLAN ID for the management VLAN.

The management VLAN is used to establish an IP connection to the switch from a
computer that is connected to a port in the same VLAN. If not specified, the active
management VLAN ID is 1 (default), which allows an IP connection to be established
through any port.

When the management VLAN is set to a different value, an IP connection can be made
only through a port that is part of the management VLAN. Also, the port VLAN ID (PVID)
of the port to be connected in that management VLAN must be the same as the
management VLAN ID.

Note:

Make sure that the VLAN that must be the management VLAN exists.

Also make sure that the PVID of at least one port in the VLAN is the

same as the management VLAN ID. For information about creating
VLANs and configuring the PVID for a port, see

Configure VLANs on

page

96

.

The following requirements apply to the management VLAN:

Only one management VLAN can be active at a time.

When a new management VLAN is configured, connectivity through the existing
management VLAN is lost.

The management station must be reconnected to the port in the new management
VLAN.

9.

Click the

Apply

button.

Your settings are saved.