NETGEAR MS510TXPP 8 Port Gigabit PoE Managed Switch - Manual (Page 170)

Smart Managed Pro Switches MS510TX and MS510TXPP
Configure Routing User Manual 170
4. Enter the switch’s password in the Password field.
The default password is password .
The System Information page displays.
5. Select Routing  > ARP > Advanced > ARP Create .
The Static ARP Configuration page displays. The page also shows the Routing VLAN
ARP Cache section.
6. In the IP Address field, specify the IP address.
This must be the IP address of a device on a subnet attached to one of the switch’s
existing routing interfaces.
7. In the MAC Address field, specify the unicast MAC address of the device.
Enter the address as six 2-digit hexadecimal numbers separated by colons, for example,
00:06:29:32:81:40.
8. Click the Add button.
The static ARP entry is added to the switch.
The following table describes the nonconfigurable information displayed on the page.
Table 48. Routing VLANs ARP Cache information
Field Description
Interface The routing interface associated with the ARP entry.
IP Address The IP address of the device (on a subnet) that is attached an existing routing interface
of the switch.
MAC Address The unicast MAC address of the attached device. The address is six two-digit
hexadecimal numbers separated by colons, for example, 00:06:29:32:81:40.
Type The type of ARP entry. Possible values are as follows:
• Static . An ARP entry that was manually configured.
• Dynamic . An ARP entry that was learned by the router.
Configure the Global Aging-Out Time for ARP
You can change the global aging-out time for the ARP table. The aging-out time is the period
after which an entry in the ARP is automatically deleted.
To configure the global aging-out time for the ARP table:
1. Connect your computer to the same network as the switch.
You can use a WiFi or wired connection to connect your computer to the network, or
connect directly to a switch that is off-network using an Ethernet cable.
2. Launch a web browser.