beautypg.com

NETGEAR MS510TXPP 8 Port Gigabit PoE Managed Switch User Manual

Page 207

background image

Smart Managed Pro Switches MS510TX and MS510TXPP

Configure Quality of Service

User Manual

207

The class name is a hyperlink to the page on which you can define the class
configuration.

The class name and class type are stated in the IPv6 Class Configuration section at the
top of the page. These fields are nonconfigurable on this page.

10.

Select one of the following Class Definition radio buttons:

Existing ACL

. From the menu, select an existing ACL for traffic classification. For

information about creating ACLs, see

Configure Access Control Lists on page

259

. If

you select this radio button, the fields on the page are disabled and you cannot define
classification rules.

Class Specific Rule

. Use class-specific rules. If you select this radio button (which is

selected by default), the fields on the page are enabled so that you can define
classification rules. See the next step.

11.

If you select the

Class Specific Rule

radio button, define the criteria that must be

associated with the IPv6 DiffServ class:

Match Every

. Select this check box to add a match condition that considers all

packets to belong to the class. The only selection from the

Match Every

menu is

Any

.

Note:

If you select the

Match Every

check box, you cannot define any other

options.

Protocol Type

. Select this check box to require a packet’s Layer 4 protocol to match

the specified protocol, which you must select from the menu. If you select

Other

from

the menu, you can enter a protocol number from 0 to 255.

Source Prefix/Length

. Select this check box to require a packet’s source prefix and

prefix length to match the specified source IPv6 prefix and prefix length. The prefix
must always be specified with the prefix length. The prefix can be in the hexadecimal
range from 0 to FFFF:FFFF:FFFF:FFFF:FFFF:FFFF:FFFF:FFFF and the prefix
length can be in the range from 0 to 128.