Display the igmp snooping querier for vlan status – NETGEAR MS510TXPP 8 Port Gigabit PoE Managed Switch User Manual
Page 142
Smart Managed Pro Switches MS510TX and MS510TXPP
Configure Switching
User Manual
142
You can use a WiFi or wired connection to connect your computer to the network, or
connect directly to a switch that is off-network using an Ethernet cable.
2.
Launch a web browser.
3.
In the address field of your web browser, enter the IP address of the switch.
If you do not know the IP address of the switch, see
The login window opens.
4.
Enter the switch’s password in the
Password
field.
The default password is
password
.
The System Information page displays.
5.
Select
Switching
> Multicast > IGMP Snooping Querier > Querier VLAN Configuration
.
The Querier VLAN Configuration page displays.
6.
From the
VLAN ID
menu, select
New Entry
.
7.
Configure the following settings:
•
VLAN ID
. The VLAN ID for which the IGMP snooping querier is to be enabled.
•
Querier Election Participate Mode
. Enable or disable querier this mode:
-
Disable
. Upon seeing another querier of the same version in the VLAN, the
snooping querier moves to the non-querier state.
-
Enable
. The snooping querier participates in querier election, in which the lowest
IP address operates as the querier in that VLAN. The other querier moves to
non-querier state.
•
Snooping Querier VLAN Address
. Specify the snooping querier IP address to be
used as the source address in periodic IGMP queries sent on the specified VLAN.
8.
Click the
Apply
button.
Your settings are saved.
Display the IGMP Snooping Querier for VLAN Status
To display querier VLAN status:
1.
Connect your computer to the same network as the switch.
You can use a WiFi or wired connection to connect your computer to the network, or
connect directly to a switch that is off-network using an Ethernet cable.
2.
Launch a web browser.
3.
In the address field of your web browser, enter the IP address of the switch.
If you do not know the IP address of the switch, see
The login window opens.
4.
Enter the switch’s password in the
Password
field.