NETGEAR MS510TXPP 8 Port Gigabit PoE Managed Switch - Manual (Page 154)

Smart Managed Pro Switches MS510TX and MS510TXPP
Configure Switching User Manual 154
From the Switching > Address Table > Advanced menu, you can access pages that are
described in the following sections:
• View and Search the MAC Address Table on page 154
• Change the Aging-Out Period of Dynamic MAC Addresses on page 155
• Add a Static MAC Address on page 156
• Remove a Static MAC Address on page 156
View and Search the MAC Address Table
To view and search the MAC Address Table:
1. Connect your computer to the same network as the switch.
You can use a WiFi or wired connection to connect your computer to the network, or
connect directly to a switch that is off-network using an Ethernet cable.
2. Launch a web browser.
3. In the address field of your web browser, enter the IP address of the switch.
If you do not know the IP address of the switch, see Access the Switch on page 14 .
The login window opens.
4. Enter the switch’s password in the Password field.
The default password is password .
The System Information page displays.
5. Select Switching > Address Table > Address Table .
The Address Table page displays. The page also displays the MAC Address Table
section.
6. From the Search By menu, select one of the following options:
• VLAN ID . In the Search By field, enter a VLAN ID.
• Mac Address . In the Search By field, enter a MAC address as six 2-digit
hexadecimal numbers separated by colons, for example, 00:01:23:43:45:67.
• Interface . In the Search By field, enter an interface number.
7. Click the Go button.
If the searched value exists, the entry is displayed.
Total MAC Addresses field shows the total number of MAC addresses in the MAC
Address Table.