beautypg.com

Vlan routing configuration – NETGEAR MS510TXPP 8 Port Gigabit PoE Managed Switch User Manual

Page 165

background image

Smart Managed Pro Switches MS510TX and MS510TXPP

Configure Routing

User Manual

165

U (Untagged)

. Select the ports on which all frames transmitted for this VLAN are

untagged. The ports that are selected are included in the VLAN.

By default, the selection is blank, which means that the port is excluded from the VLAN
but can be dynamically registered (autodetected) in the VLAN through GVRP.

10.

In the LAG table, click each LAG once, twice, or three times to configure one of the following

modes or reset the LAG to the default settings:

T (Tagged)

. Select the LAGs on which all frames transmitted for this VLAN are

tagged. The LAGs that are selected are included in the VLAN.

U (Untagged)

. Select the LAGs on which all frames transmitted for this VLAN are

untagged. The LAGs that are selected are included in the VLAN.

By default, the selection is blank, which means that the LAG is excluded from the VLAN
but can be dynamically registered (autodetected) in the VLAN through GVRP.

11.

Click the

Apply

button.

Your settings are saved.

VLAN Routing Configuration

To configure VLAN routing:

1.

Connect your computer to the same network as the switch.

You can use a WiFi or wired connection to connect your computer to the network, or
connect directly to a switch that is off-network using an Ethernet cable.

2.

Launch a web browser.

3.

In the address field of your web browser, enter the IP address of the switch.

If you do not know the IP address of the switch, see

Access the Switch on page

14

.

The login window opens.

4.

Enter the switch’s password in the

Password

field.

The default password is

password

.

The System Information page displays.

5.

Select

Routing

> VLAN > VLAN Routing Configuration

.

The VLAN Routing Configuration page displays.

6.

From the

VLAN ID

menu, select the VLAN.

This menu displays the IDs of all VLANs that are configured on the switch.

7.

In the

IP Address

field, enter the IP address to be configured for the VLAN routing interface.

8.

In the

Subnet Mask

field, enter the subnet mask to be configured for the VLAN routing

interface.

9.

Click the

Add

button.