NETGEAR MS510TXPP 8 Port Gigabit PoE Managed Switch - Manual (Page 262)

Smart Managed Pro Switches MS510TX and MS510TXPP
Manage Device Security User Manual 262
• ACL Based on Source IPv4 . Creates an ACL based on the source IPv4 address and
IPv4 address mask.
• ACL Based on Destination IPv6 . Creates an ACL based on the destination IPv6
prefix and IPv6 prefix length.
• ACL Based on Source IPv6. Creates an ACL based on the source IPv6 prefix and
IPv6 prefix length.
• ACL Based on Destination IPv4 L4 Port . Creates an ACL based on the destination
IPv4 Layer 4 port number.
• ACL Based on Source IPv4 L4 Port . Creates an ACL based on the source IPv4
Layer 4 port number.
• ACL Based on Destination IPv6 L4 Port . Creates an ACL based on the destination
IPv6 Layer 4 port number.
• ACL Based on Source IPv6 L4 Port . Creates an ACL based on the source IPv6
Layer 4 port number.
Note: For L4 port options, two rules are created (one for TCP and one for
UDP).
7. In the Rule ID field, enter a whole number in the range of 1 to 50 that is used to identify the
rule.
8. From the Action menu, select Permit or Deny to specify the action that must be taken if a
packet matches the rule’s criteria.
9. From the Match Every menu, select one of the following options:
• False . Signifies that packets do not need to match the selected ACL and rule. With
this selection, you can add a destination MAC address, destination MAC mask, and
VLAN.
• True . Signifies that all packets must match the selected ACL and rule and are either
permitted or denied. In this case, since all packets match the rule, the option of
configuring other match criteria is not offered.
10. Specify the additional match criteria for the selected ACL type.
The rule match criteria fields available for configuration depend on the selected ACL type.