Configure mld snooping querier vlan settings, Information, see, Configure mld snooping querier vlan settings on – NETGEAR MS510TXPP 8 Port Gigabit PoE Managed Switch User Manual
Page 148: For which mld snooping querier is enabled (see, Configure mld snooping querier
Smart Managed Pro Switches MS510TX and MS510TXPP
Configure Switching
User Manual
148
Configure MLD Snooping Querier VLAN Settings
To configure MLD snooping querier VLAN settings:
1.
Connect your computer to the same network as the switch.
You can use a WiFi or wired connection to connect your computer to the network, or
connect directly to a switch that is off-network using an Ethernet cable.
2.
Launch a web browser.
3.
In the address field of your web browser, enter the IP address of the switch.
If you do not know the IP address of the switch, see
The login window opens.
4.
Enter the switch’s password in the
Password
field.
The default password is
password
.
The System Information page displays.
5.
Select
Switching
> Multicast > MLD Snooping > Querier VLAN Configuration
.
The MLD Snooping Querier VLAN Configuration page displays.
6.
In the
VLAN ID
field, specify the VLAN ID on which the MLD snooping querier is
administratively enabled.
7.
From the
Querier Election Participate Mode
menu, select to enable or disable the querier
participation election mode for MLD snooping.
When this mode is disabled, on detecting another querier of same version in the VLAN,
the snooping querier moves to a non-querier state. When this mode is enabled, the
snooping querier participates in querier election where the lowest IP address wins the
querier election and operates as the querier in that VLAN. The other querier moves to
non-querier state.
8.
In the
Querier VLAN Address
field, specify the snooping querier address to be used as the
source address in periodic MLD queries sent on the specified VLAN.
9.
Click the
Apply
button.
Your settings are saved.