NETGEAR MS510TXPP 8 Port Gigabit PoE Managed Switch - Manual (Page 17)

Smart Managed Pro Switches MS510TX and MS510TXPP
Get Started User Manual 17
6. Select the switch, and then click the Configure Device button.
The page expands to display additional fields at the bottom.
7. Select the Disabled radio button.
The DHCP client is disabled.
8. Enter the static switch IP address, gateway IP address, and subnet mask for the switch.
9. Enter the switch password to continue with the configuration change.
The default password is password . You must enter the password each time that you use
the Smart Control Center to update the switch settings.
Note: If you change the default password to a custom password (which we
recommend) using the local browser interface and need to use the
Smart Control Center again, you must enter the custom password for
configuration changes to be accepted.
10. Click the Apply button.
Your settings are saved.