beautypg.com

Configure mac-based vlan groups – NETGEAR MS510TXPP 8 Port Gigabit PoE Managed Switch User Manual

Page 104

background image

Smart Managed Pro Switches MS510TX and MS510TXPP

Configure Switching

User Manual

104

You can enter a number from 0 to 7.

14.

Click the

Apply

button.

Your settings are saved.

Configure MAC-Based VLAN Groups

The MAC-Based VLAN feature allows incoming untagged packets to be assigned to a VLAN
and thus classify traffic based on the source MAC address of the packet.

You define a MAC-to-VLAN mapping by configuring an entry in the MAC-to-VLAN table. An
entry is specified through a source MAC address and the desired VLAN ID. The
MAC-to-VLAN configurations are shared across all ports of the device (that is, a system-wide
table exists with MAC address–to–VLAN ID mappings).

When untagged or priority-tagged packets arrive at the switch and entries exist in the
MAC-to-VLAN table, the source MAC address of the packet is looked up. If an entry is found,
the corresponding VLAN ID is assigned to the packet. If the packet is already priority tagged
it maintains this value. Otherwise, the priority is set to zero. The assigned VLAN ID is verified
against the VLAN table. If the VLAN is valid, ingress processing on the packet continues.
Otherwise, the packet is dropped. This implies that the user is allowed to configure a MAC
address mapping to a VLAN that was not created on the system.

Add a MAC-Based VLAN Group

To add a MAC-based VLAN group:

1.

Connect your computer to the same network as the switch.

You can use a WiFi or wired connection to connect your computer to the network, or
connect directly to a switch that is off-network using an Ethernet cable.

2.

Launch a web browser.

3.

In the address field of your web browser, enter the IP address of the switch.

If you do not know the IP address of the switch, see

Access the Switch on page

14

.

The login window opens.

4.

Enter the switch’s password in the

Password

field.

The default password is

password

.

The System Information page displays.

5.

Select

Switching

> VLAN > Advanced > MAC Based VLAN Group Configuration

.

The MAC Based VLAN Group Configuration page displays. The page also shows the
MAC Based VLAN Mapping section.

6.

In the

MAC Address

field, enter a valid MAC address to be bound to a VLAN ID.

This field is configurable only when a MAC-based VLAN is created.