beautypg.com

View the supported mibs, Configure snmpv3 users – NETGEAR MS510TXPP 8 Port Gigabit PoE Managed Switch User Manual

Page 65

background image

Smart Managed Pro Switches MS510TX and MS510TXPP

Configure System Information

User Manual

65

Authentication

. When authentication is enabled, SNMP traps are sent when events

involving authentication occur. By default, the Enable radio button is selected.

7.

Click the

Apply

button.

Your settings are saved.

View the Supported MIBs

This page displays a list of all MIBs supported by the switch.

To view the supported MIBs:

1.

Connect your computer to the same network as the switch.

You can use a WiFi or wired connection to connect your computer to the network, or
connect directly to a switch that is off-network using an Ethernet cable.

2.

Launch a web browser.

3.

In the address field of your web browser, enter the IP address of the switch.

If you do not know the IP address of the switch, see

Access the Switch on page

14

.

The login window opens.

4.

Enter the switch’s password in the

Password

field.

The default password is

password

.

The System Information page displays.

5.

Select

System > SNMP > SNMPv1/v2 > Supported MIBs

.

The Status page displays.

The following table describes the fields on the Status page.

Table 17. SNMP supported MIBs

Field

Description

Name

The RFC number (if applicable) and the name of the MIB.

Description

The RFC title or MIB description.

Configure SNMPv3 Users

Any user can connect to the switch using the SNMPv3 protocol, but for authentication and

encryption, the switch supports only one user (admin). Therefore, you can create or modify
only one profile.

To configure authentication and encryption settings for the SNMPv3 admin profile by
using the web interface:

1.

Connect your computer to the same network as the switch.