Add an entry to the arp table – NETGEAR MS510TXPP 8 Port Gigabit PoE Managed Switch User Manual
Page 169
Smart Managed Pro Switches MS510TX and MS510TXPP
Configure Routing
User Manual
169
You can use a WiFi or wired connection to connect your computer to the network, or
connect directly to a switch that is off-network using an Ethernet cable.
2.
Launch a web browser.
3.
In the address field of your web browser, enter the IP address of the switch.
If you do not know the IP address of the switch, see
The login window opens.
4.
Enter the switch’s password in the
Password
field.
The default password is
password
.
The System Information page displays.
5.
Select
Routing
> ARP > Basic > ARP Cache
.
The ARP Cache page displays.
6.
To refresh the page with the latest information about the switch, click the
Refresh
button.
The following table describes the nonconfigurable information displayed on the page.
Table 47. ARP cache information
Field
Description
Interface
The routing interface associated with the ARP entry.
IP Address
The IP address of the device (on a subnet) that is attached an existing routing
interface of the switch.
MAC Address
The unicast MAC address of the attached device. The address is six two-digit
hexadecimal numbers separated by colons, for example, 00:06:29:32:81:40.
Type
The type of ARP entry. Possible values are as follows:
• Static
. An ARP entry that was manually configured.
• Dynamic
. An ARP entry that was learned by the router.
Add an Entry to the ARP Table
You can add an entry to the Address Resolution Protocol (ARP) table.
To add an entry to the ARP table:
1.
Connect your computer to the same network as the switch.
You can use a WiFi or wired connection to connect your computer to the network, or
connect directly to a switch that is off-network using an Ethernet cable.
2.
Launch a web browser.
3.
In the address field of your web browser, enter the IP address of the switch.
If you do not know the IP address of the switch, see
The login window opens.