NETGEAR MS510TXPP 8 Port Gigabit PoE Managed Switch User Manual
Page 212
Smart Managed Pro Switches MS510TX and MS510TXPP
Configure Quality of Service
User Manual
212
•
Mark CoS
. Packets are marked by DiffServ with the specified CoS value before being
forwarded. This selection requires that the Mark CoS field is set. You must select a
CoS value from 0 to 7 from the menu.
This action can apply only to a conforming action.
•
Mark IP DSCP
. Packets are marked by DiffServ with the specified DSCP value before
being forwarded. This selection requires that the DSCP field is set. You must select a
DSCP code from the menu. If you select
Other
from the menu, you can enter an IP
DSCP value from 0 to 63. The DSCP value is defined as the high-order 6 bits of the
Service Type octet in the IP header.
This action can apply only to a conforming action.
14.
Click the
Apply
button.
Your settings are saved.
Change the Policy Attributes for an Existing DiffServ Policy
To change the policy attributes for an existing DiffServ policy:
1.
Connect your computer to the same network as the switch.
You can use a WiFi or wired connection to connect your computer to the network, or
connect directly to a switch that is off-network using an Ethernet cable.
2.
Launch a web browser.
3.
In the address field of your web browser, enter the IP address of the switch.
If you do not know the IP address of the switch, see
The login window opens.
4.
Enter the switch’s password in the
Password
field.
The default password is
password
.
The System Information page displays.
5.
Select
QoS > DiffServ > Advanced > Policy Configuration
.
The Policy Configuration page displays.
6.
Click the policy name, which is a hyperlink.
The page on which you can change the policy attributes displays.
7.
Change the policy attributes as needed.
8.
Click the
Apply
button.
Your settings are saved.