Avago Technologies LSI53C876E - Manual (Page 112)

4-18 Registers
APS Auxiliary Power Source 4
Because the LSI53C876E does not provide a PME
signal, this bit always returns a 0, indicating that no
auxiliary power source is required to support the PME
signal in the D3cold power management state.
PMEC PME Clock 3
This field is always set to 00000b because the
LSI53C876E does not provide a PME signal.
VER Version [2:0]
This field is set to 001b to indicate that the LSI53C876E
complies with Revision 1.0 of the PCI Power
Management Interface Specification.
Register: 0x44
Power Management Control/Status
Read/Write
This register applies to the LSI53C876E only and indicates the power
management control and status descriptions.
PST PME Status 15
The LSI53C876E always returns a zero for this bit,
indicating that PME signal generation is not supported
from D3cold.
DSCL Data Scale [14:13]
The LSI53C876E does not support the Data register.
Therefore, this field is always set to 00b.
DSLT Data Select [12:9]
The LSI53C876E does not support the Data register.
Therefore, this field is always set to 0000b.
PEN PME Enable 8
The LSI53C876E always returns a zero for this bit to
indicate that PME assertion is disabled.
15 14 13 12 9 8 7 2 1 0
PST DSCL DSLT PEN R PWS
0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0