Metrohm viva 1.0 Manual - Manual (Page 783)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
7 Devices
viva 1.0
￭￭￭￭￭￭￭￭ 771
Program version
Shows the program version of the device.
[Update]
Opens the Load new program version dialog window (see Chapter
7.1.6, page 733).
This button is displayed only with devices that have their own firmware. It
is only enabled if the device has an old program version that is not sup-
ported by viva and that can be updated by viva itself.
Device serial number
Shows the serial number of the device.
FPGA version
Shows the FPGA version of the device.
Set to work
Shows the date on which the device was automatically added to the
device table.
Remarks
Remarks about the device.
Entry 1,000 characters
Default value 'empty'
7.6.3 Properties - Settings
Tab: Configuration ▶ Devices ▶ [Edit] ▶ Properties... ▶ Properties - 'Device type' -
'Device name' ▶ Settings
Light source
Type
Type of light source used.
Selection continuous | pulsed
Default value continuous
Pulses per integration time
Frequency at which the lamp flashes. This parameter can be edited only if
Type = pulsed.
Input range 0 - 1,000
Default value 10