Metrohm viva 1.0 Manual - Manual (Page 747)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
7 Devices
viva 1.0
￭￭￭￭￭￭￭￭ 735
FPGA version
Shows the FPGA version of the device.
Set to work
Shows the date on which the device was automatically added to the
device table.
Remarks
Remarks about the device.
Entry 1,000 characters
Default value 'empty'
7.2.3 Properties - MSB #
Tab: Configuration ▶ Devices ▶ [Edit] ▶ Properties... ▶ Properties - 'Device type' -
'Device name' ▶ MSB #
The MSB # tabs show the properties of the MSB connector and the devi-
ces connected to it.
Request for dosing device preparation
Selects when to display the request to execute the PREP command (see
Chapter 5.5.2.7.7.1, page 492) (prepare) for the dosing device connected
to the MSB.
At program start
on | off (Default value: on)
If this check box is activated, then the request to prepare the dosing
device is displayed every time the program is started.
When attaching a dosing unit
on | off (Default value: on)
If this check box is activated, then the request to prepare the dosing
device is displayed every time a dosing unit is mounted.
Time interval
on | off (Default value: off)
If this check box is activated, then the request to prepare the dosing
device is displayed after the time interval defined below.
all
Time interval after which the request to prepare the dosing device is dis-
played.