Metrohm viva 1.0 Manual - Manual (Page 548)

5.5 Method run subwindow
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
536 ￭￭￭￭￭￭￭￭
viva 1.0
NOTE
A maximum of 10 transfer commands can be entered.
Moves the selected command up (changes the sequence).
Moves the selected command down (changes the sequence).
[New]
Opens the Transfer command dialog window for entering a new trans-
fer command (see Chapter 5.5.2.9.6.3, page 536).
[Properties]
Opens the Transfer command dialog window for editing the transfer
command selected in the table (see Chapter 5.5.2.9.6.3, page 536).
[Delete]
Deletes the selected transfer command.
Timeout
on | off (Default value: off)
If this check box is activated, then a maximum waiting time can be
entered. If not all transfer commands have finished after this time period,
the command is canceled and the next command is started.
Input range 0 - 9,999.9
Default value 1
Selection min | s
Default value s
5.5.2.9.6.3 TRANSFER - Transfer command
Dialog window: Method ▶ TRANSFER ▶ Properties... ▶ Transfer command
Name
Freely definable name for the transfer command.
Entry 50 characters
Action
Selection Read | Write | Wait for | Poll
Default value Read