Metrohm viva 1.0 Manual - Manual (Page 130)

3.6 Run subwindow
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
118 ￭￭￭￭￭￭￭￭
viva 1.0
3.6.3.8.4 Properties - Process
Tab: Workplace ▶ Run ▶ Single determination ▶ Properties Run window ▶ Prop-
erties - Single determination ▶ Process
Options for the processing of single determinations.
Method selection by assignment ID
on | off (Default value: off)
If this check box is activated, then the selected sample identification will
be used for the method selection. This identification is assigned the desig-
nation Assignment ID, which can no longer be changed. If this ID
matches an assignment ID from the sample assignment table (see Chapter
3.4.1, page 103), then the respective method from this table will be
entered in the Method field.
Selection ID1 | ID2 | ID3 | ID4 | ID5 | ID6 | ID7 | ID8 | ID9 |
ID10 | ID11 | ID12 | ID13 | ID14 | ID15 | ID16
Default value ID1
Request assignment ID
on | off (Default value: off)
If this check box is activated, then the Assignment ID will be requested
immediately after the start of the determination.
3.6.3.8.5 Properties - Data import
Tab: Workplace ▶ Run ▶ Single determination ▶ Properties Run window ▶ Prop-
erties - Single determination ▶ Data import
Activating/deactivating the import of external data for fields on the Single
determination tab.
NOTE
The successful completion of the data import is indicated during the run
by an acoustic signal (beep).
Import from barcode reader
on | off (Default value: off)
If this check box is activated, then external data is imported from the
selected barcode reader into the fields on the Single determination tab.
The instrument properties of the barcode reader will define the field into
which that data is imported (see Chapter 7.9.4, page 791).
Barcode reader
Selection of the barcode reader from which data is to be imported.