Metrohm viva 1.0 Manual - Manual (Page 520)

5.5 Method run subwindow
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
508 ￭￭￭￭￭￭￭￭
viva 1.0
￭ LIFT - Properties
Command variables
The following command variables are generated by the LIFT command in
the method run and can be used in formulas under the designation 'Com-
mand name.Variable identification':
Identification Description
BSY Command status; 1 = BUSY, HOLD or ERROR; 0 =
READY; invalid (variable not available) = Command
has never been started
FIN Command status; 1 = Command has ended at
least once, 0, invalid (variable not available) =
Command has never ended
LPO Current absolute lift position in mm (entry when end-
ing the command)
5.5.2.8.4.2 LIFT - Properties
Dialog window: Method ▶ LIFT ▶ Properties... ▶ LIFT - 'Command name'
Command name
Name of the command.
Entry 25 characters
Device
Device name
Selection of a device from those available in the device table. Only devices
with which the command can be executed are available.
Selection 'Device name' | not defined
Default value not defined
not defined
In this case, the device name must be assigned by the user at the start
of the method.
Device type
Display or selection of the instrument type. If an instrument is selected in
the Device name field, the Instrument type field can no longer be
edited and the instrument type belonging to the instrument is displayed.
If the not defined option is selected in the Device name field, all instru-
ment types or groups with which the command can be executed can be
selected, regardless of the instruments present in the device table.