Metrohm viva 1.0 Manual - Manual (Page 522)

5.5 Method run subwindow
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
510 ￭￭￭￭￭￭￭￭
viva 1.0
5.5.2.8.5 PUMP
5.5.2.8.5.1 PUMP - Overview
Dialog window: Method ▶ PUMP ▶ Properties... ▶ PUMP - 'Command name'
Command for the control of the pumps that are connected to or
installed on the sample changer.
Instruments
This command can be executed with the following instruments:
Sample changer: 814, 815, 858, 919
Appearance
The command has the following appearance:
Parameters
The parameters for the PUMP command are configured in the following
dialog window:
￭ PUMP - Properties
Command variables
The following command variables are generated by the PUMP command
in the method run and can be used in formulas under the designation
'Command name.Variable identification':
Identification Description
BSY Command status; 1 = BUSY, HOLD or ERROR; 0 =
READY; invalid (variable not available) = Command
has never been started
FIN Command status; 1 = Command has ended at
least once, 0, invalid (variable not available) =
Command has never ended
5.5.2.8.5.2 PUMP - Properties
Dialog window: Method ▶ PUMP ▶ Properties... ▶ PUMP - 'Command name'
Command name
Name of the command.
Entry 25 characters