Metrohm viva 1.0 Manual - Manual (Page 539)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
5 Method
viva 1.0
￭￭￭￭￭￭￭￭ 527
846 and 894
Selection
1 | 2 | 3 | 4
Default value 1
814, 815, 858, 919
Selection
1 | 2 | 3
Default value 1
Scan lines
Input signal
Entry of the bit pattern for the expected input signal or selection of a pre-
defined signal pattern.
It is possible to enter a bit pattern of 8 characters. The following charac-
ters can be used:
Selection 0 | 1 | * | Signal pattern
Default value *
0
Line is inactive.
1
Line is active.
*
Any line status.
Signal pattern
Selection of a signal pattern predefined in the Configuration program
part.
The input lines (inputs) are always numbered from right to left:
Input 7 6 5 4 3 2 1 0
Bit 7 6 5 4 3 2 1 0
Example:
*******1 expects an active input line 0 (1 = set).
NOTE
Input lines that are of no interest or for which no defined condition can
be predicted should be masked with an asterisk *.