Metrohm viva 1.0 Manual - Manual (Page 529)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
5 Method
viva 1.0
￭￭￭￭￭￭￭￭ 517
Device
Device name
Selection of a device from those available in the device table. Only devices
with which the command can be executed are available.
Selection 'Device name' | not defined
Default value not defined
not defined
In this case, the device name must be assigned by the user at the start
of the method.
Device type
Display or selection of the instrument type. If an instrument is selected in
the Device name field, the Instrument type field can no longer be
edited and the instrument type belonging to the instrument is displayed.
If the not defined option is selected in the Device name field, all instru-
ment types or groups with which the command can be executed can be
selected, regardless of the instruments present in the device table.
Selection 814 USB Sample Processor | 815 Robotic USB
Sample Processor XL | 858.0010 Professional
Sample Processor | 858.0020 Professional
Sample Processor | 858.0030 Professional
Sample Processor | 919.0020 IC Autosampler
plus
Default value 858.0020 Professional Sample Processor
Rack test
on | off (Default value: off)
If this check box is activated, then a check will be made to determine
whether the correct rack is in place. If this check box is not activated, then
the only check made will be to determine whether any rack has been
mounted.
Test rack
Selection of the rack name for the rack that needs to be mounted. You
can thus ensure that the method can be executed only with this rack. If a
different rack is detected when the command is executed, then a message
will be displayed and the exit track (if available) will be called.
Selection all of the sample racks present in the configu-
ration