Metrohm viva 1.0 Manual - Manual (Page 554)

5.5 Method run subwindow
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
542 ￭￭￭￭￭￭￭￭
viva 1.0
Sample amount unit
on | off (Default value: off)
If this check box is activated, then the Sample amount unit will be reques-
ted.
Analytical volume
on | off (Default value: off)
If this check box is activated, then the Analytical volume will be requested
(see Glossary, page 865).
Dilution volume
on | off (Default value: off)
If this check box is activated, then the Dilution volume will be requested
(see Glossary, page 868).
Message
on | off (Default value: off)
If this check box is activated, the message defined here appears in the
Sample data request dialog window in which the sample data is
requested at the moment of the method run (see Chapter 5.5.2.10.2.3,
page 542). The text editor for entering or changing the message is
opened with or by double-clicking on the text field (see Chapter
2.4.2, page 68).
Entry Text (unlimited)
5.5.2.10.2.3 REQUEST - Sample data request
Dialog window: Workplace ▶ [START] ▶ Sample data request
Entering sample data for the sample data variables defined in the
REQUEST command. The data in this window can be entered manually.
Pressing [Enter] completes the data input for one field and jumps to the
next one.
If fixed values are defined for sample data variables in the START com-
mand, then these will be entered in the respective parameter fields. The
fixed values displayed in italics cannot be edited.
Message
Shows the message defined in the REQUEST command.
ID1 - ID16
Sample identifications.