Metrohm viva 1.0 Manual - Manual (Page 264)

4.5 Determination overview
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
252 ￭￭￭￭￭￭￭￭
viva 1.0
[Alt] [←]
Jump to first record of previous set.
[Alt] [→]
Jump to first record of next set.
It is not possible to show more than 200 determinations at once in the
determination table. If more than 200 determinations are present in the
database then the navigation bar must be used to switch to further sets of
determinations.
4.5.1.7 Determination overview - Data set selection
Subwindow: Database ▶ Determination overview
The determinations selected in the table are displayed in blue; the
focused determination, whose data is displayed in the other subwindows,
is marked with an arrow before the line number. The first determination is
always selected and focused when a database is opened.
The following possibilities are available for the selection of determinations
in the determination table:
￭ Single determinations
Single determinations are selected by clicking on them with the mouse
within the line (including line number). This determination, whose data
is shown in the other opened subwindows, is now focused and
marked with an arrow in front of the line number.
￭ Several determinations in sequence
In order to select several determinations in sequence, the required
range can be selected with the left mouse button pressed down. It is
also possible to select a range by clicking on the first determination
and holding [Shift] while clicking on the last determination. The
last determination to be selected receives the focus.
￭ Several determinations not in sequence
In order to select several determinations not in sequence, the individual
determinations must be selected by left-clicking on them while holding
down the Ctrl key. The last determination to be selected receives the
focus.
￭ All determinations
With [Ctrl] [A] or by clicking on the uppermost left-hand table cell, all
the filtered determinations within the current set of determinations are
selected. The focus is retained.