Metrohm viva 1.0 Manual - Manual (Page 427)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
5 Method
viva 1.0
￭￭￭￭￭￭￭￭ 415
5.5.2.4.4 CALL VMS
5.5.2.4.4.1 CALL VMS - Overview
Dialog window: Method ▶ CALL VMS ▶ Properties... ▶ CALL VMS - 'Command
name'
Command for calling a VA track. The data acquired in the called VA
track is used for the calculation of the VMS value (see Glossary, page
873) for the standardization of the calibration curves in the calibration
method DT (Dilution Titration) (see Glossary, page 867). As an option, a
condition can be formulated that must be fulfilled so that the CALL VMS
command is executed.
Appearance
The command has the following appearance:
Parameters
The parameters for the CALL VMS command are configured in the fol-
lowing dialog window:
￭ CALL VMS
Command variables
The following command variables are generated by the CALL VMS com-
mand in the method run and can be used in formulas under the designa-
tion 'Command name.Variable identification':
Identification Description
BSY Command status; 1 = BUSY, HOLD or ERROR; 0 =
READY; invalid (variable not available) = Command
has never been started
FIN Command status; 1 = Command has ended at
least once, 0, invalid (variable not available) =
Command has never ended
5.5.2.4.4.2 CALL VMS - Properties
Dialog window: Method ▶ CALL VMS ▶ Properties... ▶ CALL VMS - 'Command
name'
Command name
Name of the command.
Entry 25 characters