Metrohm viva 1.0 Manual - Manual (Page 689)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
6 Configuration
viva 1.0
￭￭￭￭￭￭￭￭ 677
10 mL 33.0 mL/min
20 mL 66.0 mL/min
50 mL 166.0 mL/min
NOTE
Enter lower rates if you are using capillaries or if the solution has a
higher viscosity.
Tubing parameters
Definition of length and diameter of the tubing connected to the dosing
unit. In addition, the port assignment can be modified.
NOTE
The lengths and diameters must correspond to the actually used tubing,
because this is a prerequisite to ensure a correct execution of the PREP
and EMPTY commands. Please visit the Metrohm Web site (
Connec-
tors made of plastic ) for information on the length and diameter of
Metrohm tubing.
Dosing port 1
Port
Port to be used as dosing port 1.
Selection Port 1 | Port 2 | Port 3 | Port 4
Default value Port 1
Length
Length of the tubing on dosing port 1.
Input range 0.0 - 999.9 cm
Default value 80.0 cm
Diameter
Diameter of the tubing on dosing port 1.
Input range 0.0 - 9.9 mm
Default value 0.3 mm
Dosing port 2