Metrohm viva 1.0 Manual - Manual (Page 156)

3.6 Run subwindow
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
144 ￭￭￭￭￭￭￭￭
viva 1.0
3.6.4.9.5 Properties - Data import
Tab: Workplace ▶ Tools ▶ Sample table ▶ Open... ▶ Open sample
table ▶ [Open] ▶ Sample table 'Name' ▶ [Sample table] ▶ Properties... ▶ Proper-
ties - Sample table 'Name' ▶ Data import
Dialog window: Workplace ▶ View ▶ Properties ▶ ▶ Properties Run win-
dow ▶ Properties - Determination series ▶ Data import
Dialog window: Workplace ▶ Run ▶ Determination series ▶ [Sample table] ▶ Prop-
erties... ▶ Properties - Determination series ▶ Data import
Activating/deactivating the import of external data for sample table data
fields.
NOTE
The successful completion of the data import is indicated during the run
by an acoustic signal (beep).
Import from barcode reader
on | off (Default value: off)
If this check box is activated, then the external data from the selected bar-
code reader will be imported into the open sample table. The instrument
properties of the barcode reader will define the field into which that data
is imported (see Chapter 7.9.4, page 791).
Barcode reader
Selection of the barcode reader from which data is to be imported.
Selection 'Instrument name'
Selection Always accept data | Accept data only for
active window
Default value Always accept data
Always accept data
If this option is selected, then the data sent from the barcode reader is
imported into the open sample table for which this barcode reader is
defined as data source.
Accept data only for active window
If this option is selected, then the data sent from the barcode reader is
only imported into the open sample table if this is actively selected (i.e.
when the focus is on the window).