Metrohm viva 1.0 Manual - Manual (Page 476)

5.5 Method run subwindow
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
464 ￭￭￭￭￭￭￭￭
viva 1.0
Command variables
The following command variables are generated by the CAL LOOP Opt
command in the method run and can be used in formulas under the des-
ignation 'Command name.Variable identification':
Identification Description
BSY Command status; 1 = BUSY, HOLD or ERROR; 0 =
READY; invalid (variable not available) = Command
has never been started
C0 Coefficient c0 calculated from the calibration
C1 Coefficient c1 calculated from the calibration
C2 Coefficient c2 calculated from the calibration
C3 Coefficient c3 calculated from the calibration
COD Coefficient of determination r 2 ), which is calculated
on the basis of the calibration function and of the
confidence interval
FIN Command status; 1 = Command has ended at
least once, 0, invalid (variable not available) =
Command has never ended
LCO Loop counter = current number of completed runs,
both of Repeat loops and While loops
LST Start time of the loop command (Date/Time)
OUT Number of outliers
STC{x} Concentration of the standard x (1 - 50) used for the
command
5.5.2.6.3.2 CAL LOOP Opt - Properties
Dialog window: Method ▶ CAL LOOP Opt ▶ Properties... ▶ CAL LOOP Opt - 'Com-
mand name'
Command name
Name of the command.
Entry 25 characters
Standards
Unit conc.
Selection of the concentration unit for the standards.