Metrohm viva 1.0 Manual - Manual (Page 687)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
6 Configuration
viva 1.0
￭￭￭￭￭￭￭￭ 675
6.6.3.2 Properties - Dosing unit
Subwindow: Configuration ▶ Dosing units ▶ Properties... ▶ Dosing unit - 'Name'
Hardware
Name
Freely definable designation for the dosing unit.
Entry 24 characters
Default value 'empty'
Comment
Remarks on the dosing unit.
Entry 24 characters
Device name / dosing device
Shows the device name and the number of the MSB connector to which
the dosing device with the dosing unit is connected.
Order number
Shows the order number of the dosing unit.
Serial number
Shows the serial number of the dosing unit.
Cylinder volume
Shows the cylinder volume for the dosing unit.
Cylinder serial number
Shows the serial number of the cylinder, which is read out automatically.
It is printed on new cylinders and can be modified at any time, e.g. if the
cylinder has been replaced.
Entry 8 characters
Parameters for preparation
Configuration of the parameters which are to be used for the PREP and
EMPTY commands.
Dosing port Prep/Empty
Dosing port through which the cylinder content is to be ejected during
preparation and emptying.
Selection Dosing port 1 | Dosing port 2 | Fill port | Spe-
cial port
Default value Dosing port 1