Metrohm viva 1.0 Manual - Manual (Page 324)

4.6 Curves subwindow
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
312 ￭￭￭￭￭￭￭￭
viva 1.0
Editable only when autoscaling is deactivated.
Input range
-1.00E+12 - +1.00E+12
Default value +1.00E+12
4.6.2.2.2 Curve properties CVS - y1 axis
Tab: Workplace / Database ▶ Curves # ▶ Properties Curves # ▶ y1 Axis
Parameters for the graphical display of the curves on the y1 axis (left-hand
y axis).
Quantity
Selection of the quantity to be shown on the y1 axis.
Selection Current [A] | Voltage [V] | Time [s] | Current
measuring range [A]
Default value Current [A]
Label
Freely definable axis label for the y1 axis. If auto is selected, then the des-
ignation from the Quantity field will be used.
Selection 50 characters | auto
Default value auto
Numerical format
Selection of the numerical format for the labeling of the y1 axis.
Selection decimal | scientific | engineering
Default value engineering
decimal
The axis is labeled in the decimal format ±##.### (floating-point num-
ber).
scientific
The axis is labeled in the scientific format ±#.###e±###.
engineering
The axis is labeled in the technical format ±###.###+prefix (engi-
neering format). The prefix (m, µ, n, p) is added to the figure.
Manual scaling
on | off (Default value: off)
If this check box is activated, then the y1 axis can be manually scaled in
the curve window. In this case, the Start value and End value fields can
be edited. If this check box is not activated, then the y1 axis will be auto-
matically scaled.