Metrohm viva 1.0 Manual - Manual (Page 456)

5.5 Method run subwindow
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
444 ￭￭￭￭￭￭￭￭
viva 1.0
Identifica-
tion Description
LP.CAx Calculated value × (1 - 3) for the last measuring point on
the measuring point list
LP.EXx External value × (1 - 3) for the last measuring point of
the measuring point list
LP.CNT Intensity of the last measuring point on the measuring
point list in counts
LP.MEA Measured value for the last measuring point of the mea-
suring point list in the unit of the measured value
LP.TIM Time in s until the last measuring point in the measuring
point list is reached
LP.TRN Transmission of the last measuring point of the measur-
ing point list in %
MTE Temperature measurement with sensor; 1 = on, 0 =
off)
NMP Number of measuring points in measuring point list
STY Type of stop with which the command was stopped: 1 =
normal; 0 = manual or after error
1) Command variable is invalid for the Avantes spectrometer
5.5.2.5.5.2 MEAS Opt Conc - General/Hardware
Tab: Method ▶ MEAS Opt Conc ▶ Properties... ▶ MEAS Opt Conc - 'Command
name' ▶ General/Hardware
Command name
Name of the command.
Entry 25 characters
The general parameters for the instrument are defined on this tab.
Device
Device name
Selection of a device from those available in the device table. Only devices
with which the command can be executed are available.
Selection 'Device name' | not defined
Default value not defined
not defined
In this case, the device name must be assigned by the user at the start
of the method.