Metrohm viva 1.0 Manual - Manual (Page 544)

5.5 Method run subwindow
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
532 ￭￭￭￭￭￭￭￭
viva 1.0
5.5.2.9.5.2 RECEIVE - Properties
Dialog window: Method ▶ RECEIVE ▶ Properties... ▶ RECEIVE - 'Command name'
Command name
Name of the command.
Entry 25 characters
Wait for event/status
Selection Wait until all conditions are met | Wait until
one of the conditions is met
Default value Wait until all conditions are met
Wait until all conditions are met
A wait ensues until all of the conditions listed in the table are fulfilled.
Wait until one of the conditions is met
A wait ensues until one of the conditions listed in the table is fulfilled.
[New]
Opens the Wait for event/status dialog window for entering a new
event message which is to be waited for (see Chapter 5.5.2.9.5.3, page
533).
NOTE
A maximum of 10 event messages can be entered.
[Properties]
Opens the dialog window Wait for event/status to edit the event mes-
sage selected in the table which is to be waited for (see Chapter
5.5.2.9.5.3, page 533).
[Delete]
Deletes the selected event message.
Timeout
on | off (Default value: off)
If this option is activated, then a maximum waiting time for event mes-
sages can be entered. If none of the conditions defined above are fulfilled
after this time period, the command is canceled and the next command in
the sequence is executed.
Value
Input range 0 - 9,999.9
Default value 0