Metrohm viva 1.0 Manual - Manual (Page 773)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
7 Devices
viva 1.0
￭￭￭￭￭￭￭￭ 761
This button is displayed only with devices that have their own firmware. It
is only enabled if the device has an old program version that is not sup-
ported by viva and that can be updated by viva itself.
Device serial number
Shows the serial number of the device.
FPGA version
Shows the FPGA version of the device.
Set to work
Shows the date on which the device was automatically added to the
device table.
Remarks
Remarks about the device.
Entry 1,000 characters
Default value 'empty'
7.5.3 Properties - Tower
Tab: Configuration ▶ Devices ▶ [Edit] ▶ Properties... ▶ Properties - 'Device type' -
'Device name' ▶ Tower
NOTE
With the 858 Professional Sample Processor and the 919 IC Autosam-
pler plus, the properties of the tower, including the Swing Head
attached to it, are displayed on the Tower tab. In the case of the 814
USB Sample Processor and the 815 Robotic USB Sample Processor XL,
the model versions with one tower have one tab, Tower 1; model ver-
sions with two towers have two tabs, Tower 1 and Tower 2.
Tower parameters
Max. stroke path
Entry of the lowest permitted lift position. A lift height of 0 mm corre-
sponds to the "home position", i.e. the lift is moved all the way to the top.
Input range 0 - 235 mm
Default value 127 mm
Min. beaker radius
Definition of the minimum radius which the beakers used on the rack
must have. If the lift is moved to the work position, the beaker radii
defined in the rack table (see Chapter 6.11.2, page 719) for general sam-