Metrohm viva 1.0 Manual - Manual (Page 494)

5.5 Method run subwindow
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
482 ￭￭￭￭￭￭￭￭
viva 1.0
Add with dosing device
Automatic addition of the solution with a dosing device. The Sample
amount is added for undiluted samples, the Analytical volume for
diluted ones. The sample is added through the Dosing port 1 defined
in the configuration for the dosing unit (see Chapter 6.6.3.2, page
675).
NOTE
If the sample is to be added with a dosing device, then it is mandatory
that either the Sample amount be added as volume or that a Analyt-
ical volume be defined, otherwise an error message will appear in the
run.
Message
With manual addition, the running of the track in which the command is
located is stopped and a message is displayed.
Only editable for Addition = Add manually, otherwise disabled (includ-
ing text input field).
Selection Display standard message | Display message
defined by the user
Default value Display standard message
Display standard message
If this check box is activated, then the standard message for additions
will be displayed.
Display message defined by the user
If this check box is activated, then the message defined in the text field
will be displayed.
Dosing device
Parameters for automatic dosing. This section is displayed only when
Addition = Add with dosing device.
Dosing unit
Selection of the dosing unit with which the sample solution is to be dosed
in.
Selection 'Name of the dosing unit' | not defined
Default value not defined
'Name of the dosing unit'
Alphabetically organized selection of the dosing units from the table of
dosing units in the configuration.