Metrohm viva 1.0 Manual - Manual (Page 303)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
4 Database
viva 1.0
￭￭￭￭￭￭￭￭ 291
NOTE
The individual measuring points are no longer displayed for curves for
which the distance between two measuring points is smaller than 5 pix-
els, even if a symbol has been selected. In this case, the graphics win-
dow might be enlarged in order to display the symbols again.
Symbol color
Selection of the color for the measuring point symbol.
Selection 13 colors | light green
Default value light green
Smoothing
on | off (Default value: off)
Activates/deactivates smoothing for the curves.
Smoothing factor x axis
Factor for smoothing in the direction of the x axis.
Input range 0.01 - 1,000
Default value 0.01
Smoothing factor y axis
Factor for smoothing in the direction of the y axis.
Input range 0.01 - 1,000
Default value 0.01
Also show original curve
on | off (Default value: off)
If this check box is activated, then the original curve (solid line, same
color) will be shown in addition to the smoothed curve (dotted line).
Curve properties MEAS - Options
Tab: Workplace / Database ▶ Curves # ▶ Properties Curves # ▶ Options
Options for the graphical display of curves.
Show grid
on | off (Default value: off)
If this check box is activated, then a grid will be shown against the back-
ground.