Metrohm viva 1.0 Manual User Manual
Page 38

2.3 Formula editor
■■■■■■■■■■■■■■■■■■■■■■
26
■■■■■■■■
viva 1.0
Designation
Description
Commands
LPO
Current absolute lift position in mm (entry when ending the command)
LIFT
LST
Start time of the loop command (Date/Time)
CALL COND
CAL LOOP
Opt, LOOP
MA.CNT
Intensity for maximum measured value in counts
MEAS Opt
MA.MEA
Maximum measured value in the unit of the measured value
MEAS Opt
MA.TEM
Temperature for the maximum measured value in °C
MEAS Opt
MA.TIM
Time in s until the maximum measured value is reached
MEAS Opt
MA.TRN
Transmission for maximum measured value in %
MEAS Opt
MI.CNT
Intensity for minimum measured value in counts
MEAS Opt
MI.MEA
Minimum measured value in the unit of the measured value
MEAS Opt
MI.TEM
Temperature with minimum measured value in °C
MEAS Opt
MI.TIM
Time for the minimum measured value in s
MEAS Opt
MI.TRN
Transmission for minimum measured value in %
MEAS Opt
MTE
Temperature measurement with sensor; 1 = on, 0 = off)
CAL MEAS
Opt, MEAS
Opt, MEAS
Opt Conc,
MEAS TMF
NMP
Number of measuring points in measuring point list
CAL MEAS
Opt, CVS,
MEAS Opt,
MEAS Opt
Conc, MEAS
TMF
OUT
Number of outliers
CAL LOOP Opt
PK{x}.ABS
Absorbance of the peak x (1 - 9) in mAU
MEAS Spec
PK{x}.TRN
Transmission of the peak x (1 - 9) in %
MEAS Spec
PK{x}.CNT
Intensity of the peak x (1 - 9) in counts
MEAS Spec
PK{x}.CNR
Intensity of the peak x (1 - 9) in the reference spectrum in counts
MEAS Spec
PK{x}.CND
Intensity of the peak x (1 - 9) in the dark spectrum in counts
MEAS Spec
PK{x}.WVL
Wavelength of the peak x (1 - 9) in nm
MEAS Spec
PK{x}.SAT
Detector with peak x (1 - 9) saturated: 1 = saturated;0 = not saturated
MEAS Spec
RPM
Stirring rate in min
-1
CVS
RAN
Current absolute rotation angle of the rack in ° in relation to the axis of the
selected tower (entry when exiting the command)
MOVE
RPO
Current rack position (entry when exiting the command); 0 means 'not defined'
MOVE