Metrohm viva 1.0 Manual - Manual (Page 735)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
6 Configuration
viva 1.0
￭￭￭￭￭￭￭￭ 723
present or not. With off, no check takes place. For the Robotic arm
option, a Swing Head with beaker sensor must be installed and a suitable
work position with beaker contact must be defined for the lift, as this
position is approached for beaker recognition.
With the Beaker test parameter in the MOVE command, you can deter-
mine whether the determination is to be canceled if a beaker is missing
with or without the display of a corresponding message and whether the
series is to be continued or canceled as well.
Selection Tower | Robotic arm | off
Rack offset
The rack offset is a production-dependent tolerance value between the
upper part of the rack and the lower part. The rack offset value is deter-
mined when the rack is adjusted and displayed here. If necessary, it can be
edited.
Input range -5.00 - 5.00 °
6.11.3.3 Properties - Lift positions
Dialog window: Configuration ▶ Rack data ▶ [Edit] ▶ Properties... ▶ Rack
data ▶ Lift positions
Tower 1
Defines the lift positions for tower 1. These apply for all rack positions
except those that are defined as Special beakers.
Work position
Work position for lift 1.
Input range 0 - 235 mm
Rinse position
Rinse position for lift 1.
Input range 0 - 235 mm
Shift position
Shift position for Lift 1. Each time that the rack shifts, the lift will move to
this position if it is located at a lower lift position. If the lift is located at a
higher lift position than that defined here, then it will shift at the current
lift position. This means that the shift position must be selected so that a
safe movement across the entire rack is possible at any time.
Input range 0 - 235 mm
Special position
Special position for lift 1.