Metrohm viva 1.0 Manual - Manual (Page 168)

3.9 Curves subwindow
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
156 ￭￭￭￭￭￭￭￭
viva 1.0
3.9 Curves subwindow
3.9.1 Curve display
3.9.1.1 Curve display - General
Subwindow: Workplace ▶ Curves #
The Curves 1 and Curves 2 subwindows are subwindows in the Work-
place program part. In these subwindows, the measuring curves and cali-
bration curves generated by measuring commands during the ongoing
determination are shown.
The Curves 1 and Curves 2 subwindows can be activated in the Work-
place program part during the definition of the layout and thus rendered
visible. They can be enlarged and reduced as required, and they can also
be maximized.
NOTE
Only curves that have been generated with the CVS measuring com-
mand are displayed in this window.
3.9.1.2 Curve display CVS
3.9.1.2.1 Tabs
Subwindow: Workplace ▶ Curves #
In the curve window, a tab with the corresponding command name is
provided for each run of a VA measuring command; their sequence is
determined by the method. The upper part of these tabs shows the
recorded voltammograms or calibration curves and the lower part con-
tains information on the individual measuring curves. The
symbols
serve to maximize either the upper or the lower part to the size of the
entire curve window or reset it again.
A symbol representing the type of displayed curves is located next to the
title of the tab. You can toggle between the types by clicking on this sym-
bol.
Shows the voltammograms (see Chapter 4.6.1.2.1, page 304).
Shows the calibration curve (see Chapter 4.6.1.2.2, page 306).