Metrohm viva 1.0 Manual - Manual (Page 422)

5.5 Method run subwindow
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
410 ￭￭￭￭￭￭￭￭
viva 1.0
Selection 200 pA | 2 nA | 20 nA | 200 nA | 2 µA | 20 µA |
200 µA | 2 mA | 20 mA | 224 mA
Default value 224 mA
Minimum range
Limitation of the lowest current measurement range.
Selection 200 pA | 2 nA | 20 nA | 200 nA | 2 µA | 20 µA |
200 µA | 2 mA | 20 mA | 224 mA
Default value 20 µA
NOTE
If the Potential step time is < 4 ms, the automatic switching of the
current measurement range will no longer function optimally. If this is
the case, either increase the Potential step time or set the highest
and lowest current measurement ranges to the same value.
5.5.2.4 Call commands
5.5.2.4.1 Call commands - Overview
Menu item: Method ▶ Insert ▶ New command... ▶ Call
The following call commands can be selected:
￭ CALL
Calling normal tracks (subprograms).
￭ CALL VA
Calling VA tracks.
￭ CALL VMS
Calling VA tracks.
￭ CALL INTERCEPT
Calling VA tracks.
￭ CALL COND
Calling VA tracks.
5.5.2.4.2 CALL
5.5.2.4.2.1 CALL - Overview
Dialog window: Method ▶ CALL ▶ Properties... ▶ CALL - 'Command name'
Command for Calling normal tracks. As an option, conditions can be
formulated that must be fulfilled so that the CALL command is executed.
Appearance
The command has the following appearance: