Metrohm viva 1.0 Manual - Manual (Page 479)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
5 Method
viva 1.0
￭￭￭￭￭￭￭￭ 467
Identification Description
BSY Command status; 1 = BUSY, HOLD or ERROR; 0 =
READY; invalid (variable not available) = Command
has never been started
DBL Total duration for the processing of the command in
s
EME End measured value (measured value after process-
ing of the command) in the unit of the measured
value
ETE 1) End temperature (temperature following processing
of the command) in °C
FIN Command status; 1 = Command has ended at
least once, 0, invalid (variable not available) =
Command has never ended
IME Initial measured value (measured value before start
conditions are processed) in the unit of the measured
value
ITE 1) Initial temperature (temperature before start condi-
tions are processed) in °C
LP.CNT Transmission of the last measuring point of the mea-
suring point list in %
LP.MEA Measured value for the last measuring point of the
measuring point list in the unit of the measured
value
LP.TEM Temperature for the last measuring point of the
measuring point list in °C
LP.TIM Time in s until the last measuring point in the mea-
suring point list is reached
LP.TRN Transmission of the last measuring point of the mea-
suring point list in %
MTE Temperature measurement with sensor; (1 = on, 0 =
off)
NMP Number of measuring points in measuring point list
STY Type of stop with which the command was stopped:
1 = normal; 0 = manual or after error
1) Command variable is invalid for the Avantes spectrometer