Rockwell Automation 20Y PowerFlex 700H, 700S, and 700AFE Drive Fan Systems, Frames 9...14 - Manual (Page 44)

44 Rockwell Automation Publication PFLEX-IN029B-EN-P - August 2014
Chapter 1 PowerFlex 700H and 700S Drives - Frame 9 Procedures
1. Review the General Precautions on page 17 .
2. Remove power from the drive. See Remove Power from the Drive on page
23 .
3. Remove the lower protective cover from the drive. See Remove the Lower
Protective Cover on page
24 .
4. Remove the lower mounting bolts from the bottom of the frame.
5. Remove the four rubber bushings that cover the mounting screws for the
main fan assembly. Retain these bushings for reuse.
6. Remove the rubber bushing from the hole that covers the main fan motor
power connector at the bottom of the drive.
IMPORTANT Verify that the upper mounting bolts are secure and properly torqued
so that they will hold the drive to the wall of the system enclosure.
5
4