Rockwell Automation 20Y PowerFlex 700H, 700S, and 700AFE Drive Fan Systems, Frames 9...14 - Manual (Page 167)

Rockwell Automation Publication PFLEX-IN029B-EN-P - August 2014 167
PowerFlex 700H and 700S Drives - Frame 13 Procedures Chapter 5
21. Install the fan circuit board protection cover using the four M4 x 8 mm
POZIDRIV screws. Insert the rubber grommet into the hole in the cover.
22. Modify and connect the converter external wire connections with the
wires provided in the retrofit kit.
a. Place the converter wire harness connector X1 on the sheet cover
connector holder.
b. Connect the wire harness DC- wire on the fuse base.
c. Use two of the cable ties supplied in the retrofit kit to tie together the
wire harness and DC wires.
4
4
PZ1
0.9 N
• m (8.0 lb • in)
Series A converter
4
4
4
Series B converter
a.
b.
c.
Note: Converter section shown