Rockwell Automation 20Y PowerFlex 700H, 700S, and 700AFE Drive Fan Systems, Frames 9...14 - Manual (Page 206)

206 Rockwell Automation Publication PFLEX-IN029B-EN-P - August 2014
Chapter 7 PowerFlex 700AFE Drive - Frame 10 Procedures
9. Connect the fan power supply wires to the bottom of the fuse holders.
Note that the red wire (+DC) is connected to the left side terminal and
the black wire (-DC) is connected to the right side terminals.
10. Install the new main DC fans in the fan housings using the M5 x 10 mm
POZIDRIV screws supplied in the kit. Final torque is 3.5 N
• m (31.0
lb • in). See Remove the Main Fan Assembly on page 198 for details.
11. Remove the backing from the drive modification label and attach the label
to the front of a main fan housing.
12. Write “DC fan retrofit” and the installation date on the label.
9
Inverter section shown