Rockwell Automation 20Y PowerFlex 700H, 700S, and 700AFE Drive Fan Systems, Frames 9...14 - Manual (Page 219)

Rockwell Automation Publication PFLEX-IN029B-EN-P - August 2014 219
PowerFlex 700AFE Drive - Frame 10 Procedures Chapter 7
LCL Filter DC Fan Power Supply Kit (SK-Y1-DCPS2-F10) Removal and Installation
This kit contains the following components.
• Fan DC power supply circuit board
• New X51 cable (fan circuit board to AFE power structure connections)
• New X52 cable (fan motor thermal switch to AFE power structure
connections)
Note: It is not necessary to remove the fan assembly from the LCL filter, but by
doing so, it may be easier to replace the fan DC power supply circuit board.
The LCL filter fan DC power supply wiring diagram is shown in Figure 26 . The
diagram shows the connections to the AFE power structure and DC bus.
Figure 26 - LCL Filter Fan DC Power Supply (SK-Y1-DCPS2-F10) Wiring Diagram
X3
LCL Filter
X8
X53 (3-pin)
+ Pin = DC+ (supply)
– Pin = DC– (supply) X2
X51 (4-pin)
Pin 4 = +16.5V
Pin 3 = (fan control)
Pin 2 = –DC
Pin 1 = (fan alarm)
Fuse
X52 (4-pin)
Pin 1 = KLIXON
Pin 4 = KLIXON
X1 Fan KLIXON
X81
Fan DC Power
Supply PCB
AFE Power Structure
DC Bus
X3 on AFE Power Structure
Pin 1
Pin 2
Pin 3
Flying Lead to –DC Bus X3
IMPORTANT Before doing any work, disconnect the AFE power structure from the AC supply,
and wait until the fan stops and the indicators on the keypad turn off. (If a
keypad is not attached, see the indicator through the keypad base.) Wait 5
more minutes before doing any work on the DC-to-DC power supply. Do not
even open the cover until after this time has expired.