Rockwell Automation 20Y PowerFlex 700H, 700S, and 700AFE Drive Fan Systems, Frames 9...14 - Manual (Page 31)

Rockwell Automation Publication PFLEX-IN029B-EN-P - August 2014 31
PowerFlex 700H and 700S Drives - Frame 9 Procedures Chapter 1
Main AC Fan Inverter Capacitor (SK-H1-FANCAP-F9) Removal and
Installation
Note: The AC fan inverter capacitor replacement kit (SK-H1-FANCAP-F9)
contains a new sheet metal bracket, hardware and fasteners, and a series B
capacitor (identified in the table and shown below). The series B capacitor
(50 mm dia. x 62 mm tall) is larger than the series A capacitor (35 mm dia. x
57 mm tall). If a series A capacitor is currently installed, always replace it with the
new series B capacitor.
Follow these steps to remove, test, and replace the main AC fan inverter
capacitor.
1. Review the General Precautions on page 17 .
2. Remove power from the drive. See Remove Power from the Drive on page
23 .
Photo ID# Part Description Quantity
1 Fan capacitor 1
2 Fan capacitor, fuse holder and fan bracket 1
3 Fan inverter compartment cover 1
4 Fan capacitor nut (M12) 1
5 Fan capacitor lock washer (M12) 1
6 Stirring fan screws (M4 x 16 mm) 2
7 Fuse holder and fan inverter cover screws (M4 x 8 mm) 3
8 Fan capacitor, fuse holder and fan bracket screws (M5 x 10 mm) 2
9 Connector screw (M3 x 8 mm - for SAF option only) 1