Rockwell Automation 20Y PowerFlex 700H, 700S, and 700AFE Drive Fan Systems, Frames 9...14 - Manual (Page 105)

Rockwell Automation Publication PFLEX-IN029B-EN-P - August 2014 105
PowerFlex 700H and 700S Drives - Frame 11 Procedures Chapter 3
7. Install the fan capacitor and fuse holder adapter bracket to the new Phase
V DC fan power supply assembly.
8. Install the DC fan power supply assemblies in the reverse order of removal,
using the hardware supplied in the kit.
9. Remove the backing from the drive modification label and attach the label
to the front of a main fan housing.
10. Write “DC fan retrofit” and the installation date on the label.
Main AC Fan Inverter Capacitor (SK-H1-FANCAP-F11) Removal and
Installation
Note: The AC fan inverter capacitor replacement kit (SK-H1-FANCAP-F11)
contains a new sheet metal bracket, hardware and fasteners, and a series B
capacitor (identified in the table and shown below). The series B capacitor
(50 mm dia. x 62 mm tall) is larger than the series A capacitor (35 mm dia. x
57 mm tall). If a series A capacitor is currently installed, always replace it with the
new series B capacitor.
Photo ID# Part Description Quantity
1 AC Fan capacitor 1
2 Fan capacitor bracket (1)
(1) If a series B AC fan inverter assembly is currently installed in the drive, the sheet metal frame has been modified to accommodate
the series B (larger) capacitor. Therefore, in this case, the fan capacitor bracket, adapter bracket and adapter fastening hardware is
not needed.
1
3 M12 lock washer (for fan capacitor bracket) 1
4 M12 fastening nut (for fan capacitor bracket) 1
5 Adapter bracket
(1)
1
6 M5 x 10 mm POZIDRIV screw (for adapter bracket)
(1)
2
7 Spring washer (for adapter bracket)
(1)
1
8 M8 x 12 mm hexagonal socket screw (for adapter bracket)
(1)
1